Home > DATA POINT TARGETS
Please contact Toby Flaucher for orders:
Tel: (503) 320-4968
Email: datapointtargets@outlook.com

(Plus Shipping Carges)
Sort By:
Page of 1
Accessory: DPTBF Accessory: DPTBFVB Accessory: DPTFT1224
Accessory: DPTBF
Our Price: $540.75
Accessory: DPTBFVB
Our Price: $430.50
Accessory: DPTFT1224
Our Price: $787.50
Blind Flange Targets are set up to be clamped onto the outside of most flanges one on each side or at 90 degrees to each other. There is a clamping block on the back that can be reversed for wider flanges up to 3 ½” thick. This comes with both horizontal and vertical levels incorporated on the front plate to help level them up and a gimbal to allow to shoot the face of the flange at almost 90 degrees from centre. These are made with 1/8” thick anodised aluminium. The V-Block attachment has a blind flange target that it will bolt up to. They come with straps so you can set up the targets at 90 or 180 degrees from each other and be placed horizontally or vertically along the pipe at the cut location or P.O.C. The 150# flange target ranges from 12” to 24” with (3) gimbals one in the centre and (2) on the outside edge so you can match what is in the field. The gimbals will allow for a wide range positions close to 90 degrees from centre to shooting the face of the next flange. The target also comes with (4) line up pins that are step and size to fit the varies bolt patterns
Accessory: DPTFT1248 Accessory: DPTFT314 Accessory: DPTHX214
Accessory: DPTFT1248
Our Price: $1,993.95
Accessory: DPTFT314
Our Price: $472.50
Accessory: DPTHX214
Our Price: $281.88
Large Bore 150# flange P.O.C. This is a 12" to 48" target which uses custom made step line pins. It has 5 gimbals, 1 in the centre of the pipe and 4 on the outside edge of each wing so you can match what is in the field. The standard pipe 150# flange targets range from 3” to 14” and 1/8” thick like most gaskets. It has 1 gimbal in the centre which allows for a wide range of positions close to 90 degrees from centre to shooting the face of the next flange. The system comes with (4) line up pins that are step and size to fit the varies bolt patterns. The Heat exchanger target works with equipment that has threaded rods that protrude out from the unit. Secure the target to them and use the gimbal to shoot the centre of the flange. They range from 2” to 14” bolt pattern and are 1/8” thick.
Accessory: DPTPT214
Accessory: DPTPT214
Our Price: $490.98
The Pipe Target will fit 2” to 14” and metric pipe 63mm to 355mm grooved pipe, welded pipe, plain end pipe. There are spring steel clips to help secure it to the pipe. The frame is made from 1/8” thick anodised aluminium with a gimbal at the centre point for a wide range of positions to shoot the centre of the pipe.